Soft water salt tablet pressIt is a double-press automatic rotary continuous tablet press that can co↕mpress granular raw materials into tablets. It is mainly used in €the production of tablets in the pharmaceutical industry, as well as in the chemic§al, food, electronics and other industrial sectors. The outer co®ver is completely closed, the material is stainless £steel, and the inner table is made of stainless steel, which can maintain the surface gloσss, prevent cross-contamination, and meet GMP requirements. The following describes t™he reasons for the sticking of the soft water salt tablet press and the operation skills of the‌ equipment:

The reason for sticking and punching of the 1. soft water saltπ tablet press: sticking and punching means that when the tablet press is pressed, the tablet ≠press and the mold stick the fine powder on the surface© of the tablet press, causing the surface of the tablet press to be flat, uneven,↕ and concave. The engraving machine is easier to stick and pun<ch.

1. The surface of the punch of the equipment tablet p$ress is damaged or the surface finish is reduced. There ↔may also be anti-rust oil or lubricating oil. The surface of the new punch is ro¶ugh, or the lettering is too deep and has edges and corners. You can c↔lean the punch, replace the non-standard mold, or use a sφmall amount of liquid paraffin to wipe the surface of the lettering punch to lubricate the t↓ext. In addition, if mechanical heating causes sticking and perforation, please check the cause an★d repair the equipment.

2, lettering, punching word design is unreasonable, chang e the punch or character design accordingly.

3. Excessive water content of the particles or uneven dry and wet particles, causing→ stickiness and impact. Solution: Control the water content of the particles at about 2% £~ 3%, and strengthen the inspection of dry particles.

4. Insufficient amount of lubricant or improper model selection, too mu±ch fine powder. The amount of lubricant should be appropriately increased or replaced with a  new lubricant to remove excessive fines.

5. The fineness of raw and auxiliary materials varies greatly, resulting in une↔ven mixing or improper mixing time. Solution: Crush and screen the raw and auxili₩ary materials to make their fineness meet the quality re£quirements of the varieties, and master and control δthe stirring time of the tablet press.

Operation skills of 2. soft water salt tablet press

1. Read the instructions in detail and guide the on-site ins∑tallers or technicians during the operation of the tablet press.

2. Observe the operation of the mold, listen to the running so§und, cooperate with the motor idling, and maintain stable operation.

3. The lubrication of the soft water salt tablet press is a very impo§rtant aspect. During the operation phase, check and observe whether the machine is running for∏ insufficient lubrication, grease and oil.

4. After turning on the power switch of the equipment, test the hydraulic system, repeatedly lif±t and lift, and clean the air in the system.

5. The pressure adjustment method and pressure adjustment of the test piece m₩ay affect the hardness of the tablet, and it is also a rαeference for whether the tablet press can provide normal pressure for this p↕roduct. It is necessary to measure the effective value of theγ pressure.

6. Test and adjust the tablet speed of the soft wate'r salt tablet press to understand the speed available.

7. The filling volume is an important part of the tablet pre±ss. It is necessary to accurately determine whether the number of filling un←its is accurate, otherwise it will affect the calculation of the number of tablets.

8. Before use, the upper punch mandrel must be kept in the rising position to avoid jacking as★ much as possible.

9. After the operation is successfully completed, specific and appropriate product™ion adjustments should be made according to the hydraulic system, pressure, speed and filling v≥olume.