laboratory tablet pressThe structure is simple, the actual operation is convenient, the size is sma©ll, the weight is light, is conducive to handling and transportation. Whenβ there is no switching power supply, it can be used to press candy by hand. The following is≈ the correct operation method of the laboratory tablet press.

The laboratory tablet press can press granules and small granules into annular or special-shaped f₹lakes below 12mm, with a production capacity of 9000-15000 tabl€ets/hour, which can be adjusted at will. If you use it, you need to know that t≠he design of the equipment is simple, compact, light in weight, and ✔simple in actual operation. It is suitable for the pharmaceutical industry, food, chemical plants,¥ electronic equipment and other fields. Equipped with overpressure prot±ection device, automatic shutdown when working pres☆sure is loaded. The equipment is equipped with safety protection equipment su§ch as electromagnetic induction braking system motor, which ca<n be adjusted during operation. During the operation of th↑e laboratory tablet press, it should be noted that all oil marks, oil inlet and fric tion surfaces must be lubricated before use, and idling, so that each friction surface is cover∏ed by slick oil to increase the service life of the equipment. Several water pressure tests are× required for hand cranks before each shift and after each break. If there is no proγblem, turn on the electric tabletting sugar, the laboratory tabl♥et press can extend the service life of the mold shell.

After the laboratory tablet press is cleaned, apply a layer of food-grade stainless steel ∑grease (vehicle oil and vegetable oil are acceptable), put it into a prof₩essional maintenance box or stamping mold storage box, and put it on theγ shelf. The specification, model and specifications shou→ld be marked and stored on a shelf. After all these are co&mpleted, the laboratory tablet press will select the raw materials to make granules befo‍re compressing the candy, so as to prevent the flaky loose t‍ablets, fragments and tablet weight differences causφed by the raw materials when compressing the candy. In addition to these, it is also necessary♦ to master the correct choice of tablet type is a successful step in the stamping die of tablet ca ndy. For example, chewable tablets have high strength requirements and are easy to b↕e bitten, because most laboratory tablet presses use arc-shaped X-rays. Dents can be selected∑ for those that must be coated. Since there is no adhesive and lubricant in the raw mat÷erials of Chinese medicine pills, it is stipulated that the working pressure should₽ be large when tabletting candy, and the shape of the taλblets should be shallow and concave. Flakes with high sugar content, especially t∏he design of the device, are suitable for shallow ¶concave or flat view. The middle die can be made of carbon steel or hard aluminumΩ alloy. Deep concave plate stamping die is easy to damage, so try to avoid. Wh≥en the laboratory tablet press installs the stamping d₽ie, if you directly touch the middle die, it is very li₩kely that the stamping die will really be operated. You can put a piece of wood on the edge of the ↑table, and then shake the rocker, especially after the end of daily use, you should clean up th☆e residual powder and wipe the equipment clean. If it is not used for a long time, th$e stamping die must be removed and the friction surface of the equipment must be removed. Th→e work surface should be cleaned, coated with anti-rust agent, and covered with anti-foulγing clothing; the stamping die should be cleaned and soaked in oilγ for preservation.