laboratory tablet pressSimple structure, convenient operation, small size, light weight,≠ easy to load and unload and carry, it can also be pressed manually witho☆ut power supply, in order to meet the new requirements of suppre≤ssing Chinese herbal medicine, the machine improves the mechanical strength, improves the tra‍nsmission rate, increases the pressure and increases th e filling depth.

The laboratory tablet press can press powder and small par‍ticles into round or shaped tablets less than 12mm, wit÷h an output of 9000-15000 pieces/hour. The thickness, pressure and tabletting speed of the t♦ablet can be freely set according to customer requirements. Adjustments. The machine is simpl↔e in appearance, small in size, light in weight and ea♦sy to operate. It is suitable for pharmaceutical, f✔ood, chemical, electronic and other industries. It is equipped with an overload prote₩ction device and can automatically stop when the pressure is overl oaded.

laboratory tablet press machine operation skills:

1. The tablet press must add lubricating oil to all oil cups, oil holes and friction surfaces ☆before use. And idling makes the friction surface full of oil& film to extend the service life of the machine.

2. Before and after each shift, you must manually test several pieces. Then open the electric tabl"et without problems, which can extend the life of the mold.

3. Preserve the mold: After cleaning, apply a layer of food-grade lubricant (oil↑, edible oil), put it in a special protective box or mold storage box, put ×it on the shelf, and mark the size. Keep it on the she€lf.

4. Screen the material with a laboratory tablet press before tableting to avoid loose fragmenεts, leaf and disc weight differences caused by raw materia ls when tableting.

5. Selection of sheet type (mold): The correct selection of sh'eet type is a successful step for tabletting molds, for example, chewable tablets have high &hardness requirements and are easy to chew, and most of them use beveled flat plates; ¶film coatings can be selected as dimple shapes. In the case of →raw materials, there is no binder or lubricant in the raw materials, and the pressure r≥equired when compressing tablets is large, and the sheet type is preferably shallow. For tablets w$ith large sugar content, the sheet design is preferably ≈shallow or flat, and medium-sized molds can use alloy steel o€r cemented carbide. Deep concave molds are easily damaged and used as little as po¶ssible.

6. When removing the upper mold, press the mold with a cl₽amp (in order to prevent the tweezers from hitting the post and causing damage£, you can put a small wood on the pliers), hold the handle wi¶th one hand, and hold the pliers with the other hand. Remove the upper die.

7. When installing the mold, if you directly touch the middle mold, you can operate the mold. ↕At this time, put a piece of wood on the pressure plate and shake the handleφ!

8. After daily use, take out the remaining powder and wip♥e off all parts of the machine. If it is out of service for a lo≥ng time, you must remove the mold and rub on both sides of the machine, wipe the work surf"ace, apply anti-rust oil, and cover with dust-proof clothing;‍ the mold should be wiped clean and immersed in oil to save.α